Towertalk
[Top] [All Lists]

Re: [TowerTalk] Condensation Inside Tower Cable Box

To: Shawn Donley <n3ae@comcast.net>, "towertalk@contesting.com" <towertalk@contesting.com>
Subject: Re: [TowerTalk] Condensation Inside Tower Cable Box
From: "chuck.gooden" <chuck.gooden@comcast.net>
Date: Mon, 16 Oct 2023 16:41:15 -0500
List-post: <mailto:towertalk@contesting.com>
Mouser.com sells small air/moisture vents bade by Bud Industries for this 
purpose.Chuck K9LC
-------- Original message --------From: Shawn Donley <n3ae@comcast.net> Date: 
10/16/23  2:00 PM  (GMT-06:00) To: towertalk@contesting.com Subject: 
[TowerTalk] Condensation Inside Tower Cable Box Hello fellow TowerTalkers, I 
have an aluminum outdoor electrical enclosure at the base of my tower.  My 
underground runs of hardline enter the box through a PVC conduit elbow entering 
at the bottom of the enclosure.  The tower coax and rotor cables exit the 
bottom as well.    In humid weather, especially this time of year when the 
temperature goes down at night, I get a significant amount of condensation 
inside the enclosure, not only on the enclosure but on the outside of the 
cables within it.  Enough water to make one think there's no environmental 
protection provided by the enclosure in the first place.  I suspect the moist 
air from the conduit is the source since the underground run uses slotted 
corrugated drain pipe covered with a soil sock rather than solid wall PVC.   
Why ... concerns of long term condensation inside solid conduit...another 
subject thoroughly discussed elsewhere and hopefully not again on this thread. 
Has anyone experienced something similar and has a proven fix?   I considered a 
small 12v box fan to circulate some outside air through the enclosure but I 
think the cold box walls would just condense that moist air as well.  Perhaps a 
low wattage 12v light bulb inside the enclosure to provide some heat to keep 
the walls warmer?  Some water pipe heat tape on the outside of the box (but I 
would like to avoid any 125vac solution)?  Sealing the entry conduit is 
problematic with the several cables of different diameters.  I would not want 
to "foam" the conduit with expanding foam or something like that which would 
make pulling a new cable much more difficult. tnxN3AE 
______________________________________________________________________________________________TowerTalk
 mailing 
listTowerTalk@contesting.comhttp://lists.contesting.com/mailman/listinfo/towertalk
_______________________________________________



_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
<Prev in Thread] Current Thread [Next in Thread>