Towertalk
[Top] [All Lists]

Re: [TowerTalk] Condensation Inside Tower Cable Box

To: towertalk <towertalk@contesting.com>
Subject: Re: [TowerTalk] Condensation Inside Tower Cable Box
From: Steve Maki <lists@oakcom.org>
Date: Mon, 16 Oct 2023 15:59:54 -0400
List-post: <mailto:towertalk@contesting.com>
I have multiple conduits coming up though the bottom of a large cabinet 2.5' x 2.5' x 4' tall, open on the bottom. Sits on a concrete slab that has a hole in it almost as large as the cabinet. Doors on three sides.

One of the doors is well vented - that seems to be enough to keep it dry inside, I've never noticed any moisture. I'd try simple venting first. Maybe a large 3" or 4" PVC elbow on the side, with a screen to keep insects out.

GL, Steve K8LX

On 10/16/23 2:56 PM, Shawn Donley wrote:
Hello fellow TowerTalkers,
I have an aluminum outdoor electrical enclosure at the base of my tower. My underground runs of hardline enter the box through a PVC conduit elbow entering at the bottom of the enclosure. The tower coax and rotor cables exit the bottom as well. In humid weather, especially this time of year when the temperature goes down at night, I get a significant amount of condensation inside the enclosure, not only on the enclosure but on the outside of the cables within it. Enough water to make one think there's no environmental protection provided by the enclosure in the first place. I suspect the moist air from the conduit is the source since the underground run uses slotted corrugated drain pipe covered with a soil sock rather than solid wall PVC. Why ... concerns of long term condensation inside solid conduit...another subject thoroughly discussed elsewhere and hopefully not again on this thread. Has anyone experienced something similar and has a proven fix? I considered a small 12v box fan to circulate some outside air through the enclosure but I think the cold box walls would just condense that moist air as well. Perhaps a low wattage 12v light bulb inside the enclosure to provide some heat to keep the walls warmer? Some water pipe heat tape on the outside of the box (but I would like to avoid any 125vac solution)? Sealing the entry conduit is problematic with the several cables of different diameters. I would not want to "foam" the conduit with expanding foam or something like that which would make pulling a new cable much more difficult. tnx
N3AE
_______________________________________________



_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
_______________________________________________



_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk

<Prev in Thread] Current Thread [Next in Thread>