Free standing? If not, I would drive something into the ground with slightly
less diameter than the inside diameter of the mast and telescope the mast over
the driven stake. Then it won’t move at the bottom if it’s guyed.
Stan, K5GO
> On Oct 4, 2023, at 3:33 PM, Kurt Cathcart, KR2C <Kurt@kuhlroad.net> wrote:
>
> I have a bunch of military mast that I'm considering using in a semi
> permanent basis to hold a v-uhf vertical up about 30 feet. My idea is to
> drive a support pipe into the ground and mount the military mast to that. My
> question is, what do I use to mount the military mast to the pipe driven into
> the ground? Tie-wraps, bubble gum and duct tape fall short of the requirement.
>
>
> -Kurt, KR2C
>
>
> _______________________________________________
>
>
>
> _______________________________________________
> TowerTalk mailing list
> TowerTalk@contesting.com
> http://lists.contesting.com/mailman/listinfo/towertalk
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|