Far easier to use a post hole digger and install a 8 foot treated 4x4 a
couple of feet into the ground and then use strap to secure the mast.
Or just leave a couple of feet out of the ground and put the mast over
the pipe.
On 10/4/2023 1:32 PM, Kurt Cathcart, KR2C wrote:
I have a bunch of military mast that I'm considering using in a semi
permanent basis to hold a v-uhf vertical up about 30 feet. My idea is
to drive a support pipe into the ground and mount the military mast to
that. My question is, what do I use to mount the military mast to the
pipe driven into the ground? Tie-wraps, bubble gum and duct tape fall
short of the requirement.
-Kurt, KR2C
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|