To: | towertalk@contesting.com |
---|---|
Subject: | [TowerTalk] Tower eye bolt source? |
From: | hg chapoton <hgchapoton@gmail.com> |
Date: | Mon, 5 Jun 2023 15:35:14 -0400 |
List-post: | <mailto:towertalk@contesting.com> |
McMaster-Carr has 18" eye bolts in several shank sizes: https://www.mcmaster.com/products/screws/shank-length~18/ these are galvanized. be careful, with the plating thickness one must use the supplied nut. If this is to hold the equilizer plate, the 5/8" listed capacity of 3500# might be on the light side depending on your install? greg/na8v _______________________________________________ _______________________________________________ TowerTalk mailing list TowerTalk@contesting.com http://lists.contesting.com/mailman/listinfo/towertalk |
<Prev in Thread] | Current Thread | [Next in Thread> |
---|---|---|
|
Previous by Date: | Re: [TowerTalk] Tower eye bolt source? - NO LUCK!, W1JCW John |
---|---|
Next by Date: | [TowerTalk] Tower eye bolt source - Bolt Depot!, W1JCW John |
Previous by Thread: | Re: [TowerTalk] Tower eye bolt source? - NO LUCK!, W1JCW John |
Next by Thread: | Re: [TowerTalk] Need Eye Bolts, john |
Indexes: | [Date] [Thread] [Top] [All Lists] |