I am. 2-inch chrome-molly mast with a 4el SteppIR. Probably overkill,
but I did see some slip with the OEM mast clamp and I didn't want to
have to pin the mast.
I have;n tried your proposed installation method, but it seems like it
would work if you can slide the rotor straight in.
--
Art Greenberg
WA2LLN
art@artg.tv
On 12/25/22 10:12, Jim McDonald wrote:
Is anyone using the K7NV mast clamp with the Yaesu G2800? Any issues? Can it
replace the Yaesu brackets without raising the mast to accommodate it? (I
understand I'd have to remove the rotor to slide the K7NV clamp up onto the
mast.)
Thanks!
Jim N7US
-----Original Message-----
From: TowerTalk <towertalk-bounces@contesting.com> On Behalf Of Grant Saviers
Sent: Saturday, December 24, 2022 18:34
To: towertalk@contesting.com
Subject: Re: [TowerTalk] Proper torque settings for G-2800 rotator mast clamp
bolts?
I believe from using 3 Yaesu rotators, the 2800 bolt torque limit is more about the yield
strength of the die cast clamps than the bolt strength. A torque wrench will measure
what "1/2 to 1 turn" really means.
The bolt heads will be marked so that will reveal the bolt strength and the
permitted maximum torque can be looked up. Since everything yields a bit, it
is best to tighten in a pattern and repeat it 3 times. After a day or two is
even better but that is another tower climb.
Grant KZ1W
On 12/24/2022 11:50, Alan Higbie wrote:
As the result of an extremely high wind event, I will soon be going up the
tower to loosen the G-2800 mast clamps, realign the mast and then re-tighten
the M8 x 70 bolts.
The Yaesu G-2800 manual says:
“Caution: Do not over-tighten the nuts on the mast clamps.
They should be tightened until the spring washer becomes flat, then tightened further
by 1/2 to one turn maximum.”
I am still using the original hardware supplied with the G-2800.
These spring washers have been in service for 5 years - so their springy-ness
may not be the best indicator for torque.
I believe that torque settings depend upon the grade of hardware being used: e.g. 8.8,
9.8, 10.9 or 12.9 - but I don’t know the grade of the stock hardware.
What its the proper torque setting for these M8 x 70 bolts?
73,
~ Alan Higbie K0AV
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|