Towertalk
[Top] [All Lists]

Re: [TowerTalk] Fw: Feeding single band HF yagis 500+ ft from the shack

To: towertalk@contesting.com
Subject: Re: [TowerTalk] Fw: Feeding single band HF yagis 500+ ft from the shack
From: Wes <wes_n7ws@triconet.org>
Date: Tue, 17 May 2022 11:54:57 -0700
List-post: <mailto:towertalk@contesting.com>
I have no idea of what the towers and antennas are in this installation, except there seems to be more than one and there will be monoband Yagis installed.

I've already stated that I think OWL is a mistake, so what are the options?  In my case, I have a modest 45' tower with a small triband Yagi and a couple of wire inverted vee dipoles.  The tower is about 150 ft from the shack and I run 7/8 Heliax to the tower for the tribander and 1/2 Heliax for the dipoles.  But... I bought this stuff as reel ends years ago and paid $100 for the 7/8 and who knows how much for the 1/2".  I bought the tower and rotor used for $300 and put it up myself 20+ years ago.  If this tower was 500' from the shack and I wanted to run 7/8 Heliax today, the cost would be comparable to the whole installation.

Contrast this to a couple of local friends who have super-duper motorized Tashjian towers and ginormous rotors spinning huge Steppir beams.  They have $25-30K in these installations.  In this case the cost of 500 ft of 7/8" (Heliax AVA $3.81/100 at Tessco)) cable adds about 10% and 1 dB loss @28Mhz.

I know that we are programmed to want big coax for long runs, but consider dropping down to 1/2" Heliax.  The cost is about 40% less ($2.30/ft at Tessco) and the loss is only 1.7 dB @28MHz and proportionally less at 20 meters.  In fact on 20 meters, you would be hard pressed to tell the difference.

Wes  N7WS


On 5/16/2022 3:39 PM, dave arruzza via TowerTalk wrote:
  To all...
I have a new QTH and the towers for the monoband yagis will be 500-600 feet 
away from the shack.
I remember reading about utilizing 2 transformers and open wire line to 
minimize loss.
One transformer at the tower base to transform the yagi coax to open wire.
A run of open wire line to another transformer at the shack end.
Then coax to the shack.
I know that I can buy hardline to accomplish this but that becomes costly.
73 Dave W1CTN / 4
_______________________________________________



_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk

_______________________________________________



_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
<Prev in Thread] Current Thread [Next in Thread>