Towertalk
[Top] [All Lists]

Re: [TowerTalk] Questions on Low band receiving antennas in forests and

To: <towertalk@contesting.com>
Subject: Re: [TowerTalk] Questions on Low band receiving antennas in forests and wetlands along ridgelines and ravines.
From: <john@kk9a.com>
Date: Sun, 5 Dec 2021 18:00:50 -0500
List-post: <mailto:towertalk@contesting.com>
W3LPL has a lot of Beverage information in his low band presentation.

http://www.k3lr.com/Dayton/Dayton2016/w3lpl.pdf

John KK9A

kq2m wrote:

I want to supplement my transmitting antennas with the most useful 
low-noise low-band receiving antennas possible that I can put up in 
dense forest and with extremely challenging topography.

My qth and surrounding woods are on a hilltop with extensive and steeply 
angled jagged ledge, many ridgelines, ravines and wetlands and areas of 
standing water and marsh, varying in height from ~ 750' - 820' ASL.  
Past where I would be able to put receiving antennas, there are very 
sharp dropoffs to South and West of several hundred feet.  It is 
beautiful but NIGHTMARISH to walk through the woods under the best of 
cndx (like today) but it is a true HORROW SHOW when all the thorns 
bushes and dense vegetation is growing rapidly and the Deer Ticks and 
mosquitos are everywhere.  It's even worse in snow as the ledge and rock 
slopes become exponentially more dangerous to access and there is ledge 
EVERYWHERE.

Complicating matters are areas of the woods that resemble the moguls on 
a ski slope only more spread out.  Some of these moguls can approach 30' 
high with the ridgelines even taller than that.  While they somewhat run 
in the same direction ENE to WSW others run on steeply sloping hills 
like a series of "steps".  One ridge runs North to South on the side of 
a hill; drops 15' feet then there is a another ridge then another drop 
of 15' or so to a ravine and standing water and muck pond about 20' 
across.  And there are flatter areas of ledge that have what appears to 
be a boulder on it about 5' high and 30' long right in the middle of a 
flat spot.  There are a few formations like this in other areas as well. 
  The result is that there are very few areas open for more than 100' in 
any direction without running into these rock formations and steep hills 
and dropoffs.

Now that I have described the terrain, my questions will make more 
sense:

1) Is that a formula specific to beverage antennas for determining 
length?  Or should I used the standard dipole formula 1/2 wavelength = 
468/ f?

2) What is the effect on a terminated directional beverage (terminated 
at the back end that runs downhill at an 8% slope?  If the maximum of 
the lobe is at say 15 degrees on flat ground, does the lobe maximum drop 
to an even lower angle?  Or does the lobe change? or both?

3) Same question but with the beverage now running uphill at a 5% slope.

4) Same question but with a 20' high "Hump" in the middle? as the 
beverage starts and is terminated on a flat spot, runs to the top of a 
ridge and then back down again on the other side.

5) If you put a phased array of verticals NW to SE (with pattern 
broadside to the direction of the elements - receiving NE) in a flat 
spot that then points directly into a 30' high ridge to the Northeast 
50' from the front of the array, have you essentially turned a low angle 
receiving array into a created a high angle receiving array?

6) What happens when you have 4 ground mounted receive verticals with 
that large 5' boulder taking up of the space in the middle of them?  
What does that do to the pattern?

7) Let's say that you have a 6 L array of receive verticals in 2 rows of 
three with each line  pointing NW to SE (pattern broadside NE) and they 
are phased.  But instead of being on flat ground However, they are on 
the side of a steeply sloping hill so that the first row is at 820' asl 
and the 2nd row is in the same direction but at 800' asl.  How might 
that affect the pattern?  (for purposes of this question ignore the 
impact of ground being "ledge" rather than soil.

8) Now lets say that you have transmitting antennas for 160, 80 and 40 
nearby.  How far do the receive verticals and beverages have to 
physically be from the radials of the 160 Inv L, 80 M 4-square and from 
the 40 meter wire beam before the performance of either the transmitting 
antennas or receiving antennas starts to degrade?  A formula for 
distance in wavelengths would be most helpful.

9) How far apart fractions of a wavelength do the beverages have to be 
from each other before their performance starts to degrade?

10) What is the impact on beverage receive performance if the RG6 Quad 
Shield coax to the shack instead of running along the forest floor, 
instead runs horizontal and parallel to the beverage?  I am thinking of 
keeping it elevated to greatly reduce the opportunity of critters to 
chew on it but I don't want to impact the performance of the beverage.

11) Is there any performance advantage if I were to terminate the 
beverage with a ground rod and radials in that standing water on the 
hilltop?  Or does it not make a difference?

Finally, I have read about many preferred beverage lengths for 40, 80 
and 160 but few if any seem  to be based on an established formula to 
calculate their lengths.  What formulas and multiple of wavelengths 
would you use and why?

12) How many wavelengths on 40 is too long and how many is too short?  
Same question for 80?  Same question for 160.  I know that these answers 
vary by band which is why I am asking.

They are challenging questions that are not really covered in anything 
that I have read.  I would appreciate all of your thoughts and insights!

Tnx & 73


Bob, KQ2M

_______________________________________________



_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk

<Prev in Thread] Current Thread [Next in Thread>