Hello to the group. Will be getting a 35' used R25 next week but it looks
like installation at home might not be safe due to proximity to trees and
power lines. Plan B is a roof mounted Glen Martin 4 1/2' tower which I
bought recently plus rotor, thrust bearing and 5 1/2' mast.
I have some questions for those that have done this. Single story house
(15' roof peak) + GM quadpod, rotor and mast would make the yagi a minimum
of 5' above the roof (20' above ground). Top of the mast would be 8' over
house and 23' above ground respectively. Coming from a yard mounted 6-BTV
this should be an improvement.
I have a refurbished CC A-3 (20-15-10) and new D4 (40-10) that I can
install. Given the short mast, my options are:
1) A3 just above the thrust bearing and D4 3' higher, same orientation,
separate coaxes.
2) Turn the D4 90 degrees offset, same spacing and separate coaxes.
3) Replace the A3's driven element with the D4 so same plane and one coax.
4) Mount them on same boom and short-wire the feedpoints as one.
5) Just do the A-3 and build a dipole for 40m (+80m).
6) Roof mount the 6-BTV as a last resort.
I will be using W2FMI style current baluns and not the coaxial coils often
seen.
I've been toiling if this is even worth doing given the effort at such a
low height to poke holes into a new OSB/shingled roof. I have a few tree
branch options around 30' for wire antennas instead.
I do mostly domestic contests and CWOps from the Midwest US (Wisconsin) and
don't expect rare DX results.
Hope this makes sense and appreciate any guidance.
73,
Tony, KX3H
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|