Look for bicycle tools. A cone wrench is a very thin wrench used to remove the
nut and cone to access wheel bearings. Park Tool is one such manufacturer.
73,
Jim,
W5QM
Sent from my iPhone
> On Jul 21, 2020, at 18:28, Don <w7wll@peak.org> wrote:
>
> Ah McMaster, should have thought of that. Need a 14MM flat to get at the
> inner nut of the bearings in the XYL's glider chair. A happy wife makes it
> easier to be an active ham!!!!!
>
> Don W7WLL
>
>> On 7/21/2020 4:12 PM, Ron Gorski wrote:
>> Check McMaster-Carr online catalog
>> N9AU
>>
>> -----Original Message-----
>> From: TowerTalk <towertalk-bounces@contesting.com> On Behalf Of Don
>> Sent: Tuesday, July 21, 2020 10:27 PM
>> To: Towertalk <towertalk@contesting.com>
>> Subject: [TowerTalk] Flat Wrenches
>>
>> And metric.
>>
>> Don W7WLL
>>
>>
>> On 7/21/2020 2:03 PM, K9MA wrote:
>>
>> Speaking of which, it's hard to find wrenches thin enough to lock two
>> 6-32 or 8-32 nuts together. I have one old, cheap, Craftsman set that works,
>> but sooner or later I'm going to lose one of those up on the tower. All the
>> small wrench sets ("Ignition Wrenches") available seem to be too thick.
>> Short of grinding them down, does anyone know where to get thin ones in SAE
>> sizes?
>>
>> _______________________________________________
>>
>>
>>
>> _______________________________________________
>> TowerTalk mailing list
>> TowerTalk@contesting.com
>> http://lists.contesting.com/mailman/listinfo/towertalk
>>
>>
> _______________________________________________
>
>
>
> _______________________________________________
> TowerTalk mailing list
> TowerTalk@contesting.com
> http://lists.contesting.com/mailman/listinfo/towertalk
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|