Towertalk
[Top] [All Lists]

Re: [TowerTalk] Flat Wrenches

To: towertalk@contesting.com
Subject: Re: [TowerTalk] Flat Wrenches
From: Don <w7wll@peak.org>
Reply-to: "Tucker, Don" <w7wll@arrl.net>
Date: Tue, 21 Jul 2020 16:27:55 -0700
List-post: <mailto:towertalk@contesting.com>
Ah McMaster, should have thought of that. Need a 14MM flat to get at the inner nut of the bearings in the XYL's glider chair. A  happy wife makes it easier to be an active ham!!!!!

Don W7WLL

On 7/21/2020 4:12 PM, Ron Gorski wrote:
Check McMaster-Carr online catalog
N9AU

-----Original Message-----
From: TowerTalk <towertalk-bounces@contesting.com> On Behalf Of Don
Sent: Tuesday, July 21, 2020 10:27 PM
To: Towertalk <towertalk@contesting.com>
Subject: [TowerTalk] Flat Wrenches

And metric.

Don W7WLL


On 7/21/2020 2:03 PM, K9MA wrote:

Speaking of which, it's hard to find wrenches thin enough to lock two
6-32 or 8-32 nuts together. I have one old, cheap, Craftsman set that works,
but sooner or later I'm going to lose one of those up on the tower. All the
small wrench sets ("Ignition Wrenches") available seem to be too thick.
Short of grinding them down, does anyone know where to get thin ones in SAE
sizes?

_______________________________________________



_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk


_______________________________________________



_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
<Prev in Thread] Current Thread [Next in Thread>