I had the same problem last year. It got so bad that the manual encoder
really didn't work at all. Sent the unit back to HyGain and they replaced
the encoder. Very reasonable cost and then they also updated the firmware to
the latest. You could probably replace the encoder yourself.
Steve
KA2KON
-----Original Message-----
From: Eric Rosenberg
Sent: Sunday, February 2, 2020 00:16
To: towertalk@contesting.com
Subject: [TowerTalk] HyGain DCU-3 Firmware Upgrrade?
My DCU-3 controller has the last/latest software, v1A, released in 2014.
While I like the box and use the programmed headings much of the time, I
am frustrated by the manual position-setting encoder. It takes many,
many turns in order to get to where you want to go.
Is there a fix or workaround to make that more manageable? I hope so!
73,
Eric W3DQ
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|