[TowerTalk] HyGain DCU-3 Firmware Upgrrade?

["Eric Rosenberg" <ericrosenberg.dc@gmail.com>]

My DCU-3 controller has the last/latest software, v1A, released in 2014.

While I like the box and use the programmed headings much of the time, I 
am frustrated by the manual position-setting encoder. It takes many, 
many turns in order to get to where you want to go.
Is there a fix or workaround to make that more manageable?  I hope so!

73,
Eric W3DQ





_______________________________________________



_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk