Kris,
I have a JK 403 40M yagi. It does not use the linear loading wires like the
older Force 12 did. It uses a small shunt coil at the antenna feed points.
How about using stainless steel rod ?
I don't know what the diameter of the wires are but I just looked at an on line
company that has 1/4" dia, 316 SS rod it up to 144" long.
SS should outlast the alumaweld.
Bob
K6UJ
> On Dec 21, 2019, at 7:50 AM, K9MA <k9ma@sdellington.us> wrote:
>
> I don't know how similar it is, but it might be worthwhile downloading the
> JK403 manual to see if there are any ideas there you can use.
>
> 73,
> Scott K9MA
>
> On 12/20/2019 14:01, N5KM - Kris wrote:
>> Hi all,
>>
>> I’m rebuilding my Force12 40m yagi. What would you recommend as replacement
>> for the alumoweld linear loading wires? Some of these wires have snapped in
>> the past due to years of vibration.
>>
>> Note: as part of the rebuild I am adding truss supports for the 3 elements
>> in order to remove the stress on the linear loading wires.
>>
>> 73,
>>
>> Kris N5KM
>> _______________________________________________
>>
>>
>>
>> _______________________________________________
>> TowerTalk mailing list
>> TowerTalk@contesting.com
>> http://lists.contesting.com/mailman/listinfo/towertalk
>
>
> --
> Scott K9MA
>
> k9ma@sdellington.us
>
> _______________________________________________
>
>
>
> _______________________________________________
> TowerTalk mailing list
> TowerTalk@contesting.com
> http://lists.contesting.com/mailman/listinfo/towertalk
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|