thanks John
DXE have it on 6063 material a reasonable price
73,
Jorge
El lun., 18 nov. 2019 a las 11:17, <john@kk9a.com> escribió:
> If it is just the tip, .058 wall that is commonly available on the ham
> sites is better. I use Ø1/2 x .058 wall 6061-T6 tips on my homebrew
> 20m beams with no issues and no dampening rope. I used the same
> element design at my Aruba QTH which is constantly windy and I had no
> breakage or vibration problems there either. If tips are breaking
> perhaps there is something wrong with the rest of the element taper
> design.
>
> John KK9A
>
>
> Jorge Diez - CX6VM wrote:
>
> hello
>
> third time I have my M2inc 15 mts yagi tips broken, now on driven element
>
> 2 years ago, M2inc asked me $28 for a 1/2´´ x .049 x 31´´ long tube, very
> expensive, but since i also needed the 3/4 x 60´´ SOE section, i needed to
> but at M2inc
>
> Just for the tip, I think I can buy any 1/2´´ aluminium tube, right? Since
> i am not good at US dimensions, just need to be sure that this will work
>
> thanks!
>
> --
> 73,
> Jorge
> CX6VM/CW5W
>
>
> _______________________________________________
>
>
>
> _______________________________________________
> TowerTalk mailing list
> TowerTalk@contesting.com
> http://lists.contesting.com/mailman/listinfo/towertalk
>
--
73,
Jorge
CX6VM/CW5W
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|