If it is just the tip, .058 wall that is commonly available on the ham
sites is better. I use Ø1/2 x .058 wall 6061-T6 tips on my homebrew
20m beams with no issues and no dampening rope. I used the same
element design at my Aruba QTH which is constantly windy and I had no
breakage or vibration problems there either. If tips are breaking
perhaps there is something wrong with the rest of the element taper
design.
John KK9A
Jorge Diez - CX6VM wrote:
hello
third time I have my M2inc 15 mts yagi tips broken, now on driven element
2 years ago, M2inc asked me $28 for a 1/2´´ x .049 x 31´´ long tube, very
expensive, but since i also needed the 3/4 x 60´´ SOE section, i needed to
but at M2inc
Just for the tip, I think I can buy any 1/2´´ aluminium tube, right? Since
i am not good at US dimensions, just need to be sure that this will work
thanks!
--
73,
Jorge
CX6VM/CW5W
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|