Somewhat related, but i have my guess 50 of these RFS 1-5/8" connectors
new in the bag, both long barrel N type [female] male and 7/16" Din male
and female $10.00 your choice
And even more RFS 7/8" male female N and Din type ..
Thanx mac/mc w5mc
On 7/23/2019 10:04 AM, Jeff DePolo wrote:
Your email came through as one big block so I'm not going to bother quoting.
1. Don't use Commscope/Andrew AL connectors on RFS.
2. D01K "Premium" connectors have better PIM performance, but there's no
reason to need them for your non-duplex or non-multi-carrier installation.
For your intended use, I'd stick with older versions like 072, especially if
you like the "longer finger" design of the Commscope connectors, although I
don't believe your concerns are warranted if the connectors are properly
installed. Keep in mind that the current flow is on the *outside* of the
center conductor, not the inside, so having more "depth" inside the center
conductor as far as contact goes doesn't buy you anything.
3. Integral weatherproofing in the form of O-rings at both the interface
and connector body is "a good start" but it isn't a replacement for real
external weatherproofing.
--- Jeff WN3A
---
This email has been checked for viruses by Avast antivirus software.
https://www.avast.com/antivirus
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|