Topband: In need of a Rohn 25 top plate

[terry burge <ki7m@comcast.net>]

Hi folks,


I am in need of a Rohn 25 flat top plate or maybe a strong rotor/bearing plate. 
I've got to make a custom pulley and smaller return pulley setup for using my 
Ramsey worm gear winch to raise and lower a thousand pounds of tower from the 
ground up. Running the winch cable up the gin pole, out to a block-n-tackle on 
the tower, then back to the other side of the flat top plate is what I have in 
mind. I've done it before and it self aligns the tower great as well as 
dividing the load in half. My tower weighs just under 1000#'s and so whatever I 
come up has to be strong and may well require some welding and drilling. The 
top plate doesn't have to be pretty, just work.


Terry

KI7M

_________________
Searchable Archives: http://www.contesting.com/_topband - Topband Reflector