I can solve this problem!!
Just cut off the ends before you stretch the wire!!!
On Sun, 10 Mar 2019 14:14:24 -0700 jimlux <jimlux@earthlink.net> writes:
> On 3/10/19 1:09 PM, Jim Brown wrote:
> > On 3/10/2019 12:32 PM, Gedas wrote:
> >> In my mind I envisioned if I had a 300' length of say #12 and
> tried a
> >> pre-stretch that it would break near one of the ends and no where
> near
> >> the middle. Has that been your experience?
> >
> > When doing the pre-stretching, the wire ALWAYS breaks at one end
> or the
> > other. We've done this at least ten times. (That is, with 3-4
> spools,
> > which I think were 1,000 ft).
>
> Probably because however you attach it to the end point increases
> the
> local stress (twisting, bending, what have you)
>
> _______________________________________________
>
>
>
> _______________________________________________
> TowerTalk mailing list
> TowerTalk@contesting.com
> http://lists.contesting.com/mailman/listinfo/towertalk
>
____________________________________________________________
Judge Judy Steps Down After 23 Years Over This Controversy
glancence-hality.com
http://thirdpartyoffers.juno.com/TGL3141/5c85839767303960e05st02vuc
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|