I suggest you contact Val LZ1VB at val@acom-bg.com
In my experience, the customer support from ACOM is outstanding!
Marsh, KA5M
-----Original Message-----
From: TowerTalk <towertalk-bounces@contesting.com> On Behalf Of W1JCW John
Sent: Friday, November 9, 2018 6:46 AM
To: towertalk@contesting.com
Subject: [TowerTalk] Arc fault Acom 2K
Have a strange problem in the shack.
Run the same antennas and had no issues, put in line my Yaesu 5000 and
palstar AT.
All antennas tune flat 1:1 but when I run QRO the Acom 2K comes up with arc
fault even with low drive of 20watts.
I can place a load at the end of the coax outside and have no issues but
when I got to any antenna 260' center fed dipole or a vertical I get a fault
and the amp shuts down.
Sounds like an RF issue but why now when nothing has changed outside?
Have not seen anything like this in 40yrs I've been operating.
73-
W1JCW
John
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|