Towertalk
[Top] [All Lists]

Re: [TowerTalk] Alfa spid and Green Heron controller

To: Phil Snyder <n9lah@comcast.net>
Subject: Re: [TowerTalk] Alfa spid and Green Heron controller
From: Tim Duffy <k3lr@k3lr.com>
Reply-to: k3lr@k3lr.com
Date: Sun, 23 Sep 2018 13:46:03 -0400
List-post: <mailto:towertalk@contesting.com>
HI Phil: 

Have you contacted W2FU at Green Heron for help? His customer service is
really good. Reach out to him 

73 

Tim K3LR 

On 2018-09-23 13:34, Phil Snyder wrote:

> Howdy TTers
> 
> I am currently trying to hook my new Alfa Spid RAK rotor to my Green Heron 
> RT21 controller.
> 
> The manual I have for the controller states that rotor terminals 1 and 2 are 
> for Motor CW and CCW and the  Ground and Positive are on rotor terminals 3 
> and 4.
> 
> The manual for the rotor states that rotor terminals 1 and 2 are for motor 
> drive and that 3 and 4 are for impulse sense.
> 
> I hooked it up according to the rotor directions and to the controller since 
> it had been on an Alfa Spid already and it does not turn the rotor. I get a 
> "No Motion" error on the control box. At this point I am hesitant to switch 
> the wires around until I get some confirmation as to what is and isn't 
> correct ( I don't want to fry anything!)
> 
> Thanks
> 
> Phil
> 
> N9LAH
_______________________________________________



_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk

<Prev in Thread] Current Thread [Next in Thread>