Towertalk
[Top] [All Lists]

Re: [TowerTalk] prop pitch

To: towertalk@contesting.com
Subject: Re: [TowerTalk] prop pitch
From: Patrick Greenlee <patrick_g@windstream.net>
Date: Thu, 15 Mar 2018 06:44:55 -0500
List-post: <mailto:towertalk@contesting.com>
I had my plate sent to K7NV for a perfect fit.  Saving a few bucks and not having  a good fit didn't seem to be a good option.

Best of luck to you on your adventure.

Patrick        NJ5G


On 3/15/2018 5:03 AM, Rick wrote:
I have ordered a new crankup tower and would like the rotor mounting plate to 
be drilled at the factory for the hole pattern of a prop pitch rotor.
I don’t know if all or most prop pitch rotors have the same hole pattern or 
not. I have emailed K7NV but have not received a reply yet. The factory
is pushing me for an answer. Can anyone offer some guidance?

Thanks

Rick
N4HU
_______________________________________________



_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk

_______________________________________________



_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
<Prev in Thread] Current Thread [Next in Thread>