[TowerTalk] prop pitch

["Rick" <n4hu@mindspring.com>]

I have ordered a new crankup tower and would like the rotor mounting plate to 
be drilled at the factory for the hole pattern of a prop pitch rotor.
I don’t know if all or most prop pitch rotors have the same hole pattern or 
not. I have emailed K7NV but have not received a reply yet. The factory
is pushing me for an answer. Can anyone offer some guidance?

Thanks

Rick
N4HU
_______________________________________________



_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk