Towertalk
[Top] [All Lists]

Re: [TowerTalk] Measuring Common Mode with Anritsu VNA

To: Máximo EA1DDO_HK1H <ea1ddo@hotmail.com>
Subject: Re: [TowerTalk] Measuring Common Mode with Anritsu VNA
From: Norm n3ykf <normanlizeth@gmail.com>
Date: Sun, 31 Dec 2017 14:29:08 -0500
List-post: <mailto:towertalk@contesting.com>
Maximo,

Did you find the find the windows software? Most of the values you're
seeking could be derived using Master Sweep Tools.

https://www.anritsu.com/en-US/test-measurement/support/downloads/software/dwl010346

Line sweep tools is one. VMA master is aother. Both are completely
free.LST records datam MST allows far more than basic manipulation

MIne is odd. It requires a rs-232 dummy mode, then an rs cable.

On Sat, Dec 30, 2017 at 3:04 PM, Máximo EA1DDO_HK1H <ea1ddo@hotmail.com> wrote:
> Hi all,
>
>
> I have in my hands a very nice device called "VNA Master" from Anritsu, model 
> MS2025B.
>
> The thing is I am trying to measure a Common Mode choke with this VNA, using 
> S21 mode on the braid of a coax cable with different toroid combinations, but 
> my knowledge is limited and I am not sure if this device is able to show the 
> common mode on screen (I think is called "complex impedance").
>
>
> The options available for the trace are:
>
> Log Mag
>
> Phase
>
> Real
>
> Imaginary
>
> Log Mag/2
>
> Log Polar
>
> Real Impedance
>
> Imaginary Impedance
>
>
> (Plus some more; SWR, Group delay, Linear Polar, Smith Chart, etc.)
>
>
> Is any of the above types useful to show Common Mode Choke on screen?
>
>
> Then , the Marker has some more options to show additional information.
>
> Apart from above list, there are some extra options:
>
>
> Impedance (Z)
>
> Admittance (Y)
>
> Normalized Impedance (NZ)
>
> Normalized Admittance (NY)
>
> Polar Impedance (PZ)
>
>
> So, I am not sure if any of those options are good to shown the "choke 
> impedance" on screen, without additional calculations.
>
>
> What I can do, and in fact I do, is to export the measure in .s2p Touchstone 
> format, then apply some maths on a excel sheet to convert LogMag and Phase to 
> complex R, complex I, and finally complex Z. All of that on Excel.
>
> But to get that directly on screen would be much better.
>
>
> Thank you very much.
>
> Happy New year.
>
>
> 73, Maximo
>
>
>
> _______________________________________________
>
>
>
> _______________________________________________
> TowerTalk mailing list
> TowerTalk@contesting.com
> http://lists.contesting.com/mailman/listinfo/towertalk
_______________________________________________



_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
<Prev in Thread] Current Thread [Next in Thread>