Hi all,
I'm considering shut feeding one of my newly installed towers for 80/160. I
had good luck with this when I lived in Colorado and would like to try this
again in AZ.
The tower is 70' of Rohn 45 with an XM-240 (reflector grounded) on the top. In
my previous installation, I used 1/2" copper tubing spaced 12" off the face of
the tower with the tap around 40'. The match was a simple Omega match using
just capacitance in the matching network.
My question - would someone much smarter than me be willing to model my tower
and provide direction on the matching network?
73
Kelly - N0VD
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|