AUTOEZ is a wonderful program, easy to use and great support. EZNEC w/o
AutoEZ, not so wonderful.
Stan, K5GO
> On Nov 20, 2017, at 5:46 PM, <john@kk9a.com> <john@kk9a.com> wrote:
>
> YO and AO were really great at optimizing. Especially YO which was super
> easy to use and very fast. I designed all of my P40A Yagis with it and they
> worked well. I have EZNEC now which works well for modeling however it does
> not optimize and there is no desire to add that feature. The only option is
> to purchase third party software and also Microsoft Excel.
>
> I believe 4NEC2 will optimize and it's free. I downloaded it months ago but
> never tried it.
>
> GL
>
> John KK9A
>
>
> To: "towertalk@contesting.com" <towertalk@contesting.com>
> Subject: [TowerTalk] Yagi Optimizing Software
> From: Ray Conrad NM2O <nm2o@outlook.com>
> Date: Mon, 20 Nov 2017 17:22:50 +0000
> List-post: <mailto:towertalk@contesting.com>
> I have used YO in the past with good results.
>
> It's still available on an old DOS computer.
>
>
> What current software has optimizing routines?
>
> I have older versions of YW and EZNEC.
>
> I don't see optimizing routines in either.
>
>
> 73,
>
> Ray
>
> _______________________________________________
>
>
>
> _______________________________________________
> TowerTalk mailing list
> TowerTalk@contesting.com
> http://lists.contesting.com/mailman/listinfo/towertalk
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|