MMana-GAL has basic optimizing and it's very popular in EU - freeware. I
learned modeling using MMANA but eventually stopped using it because
everyone that I talked too used EZNEC and getting help with use or design
was hard as they did not know MMANA.
AutoEZ is an Excel-based toolset serving as a front end for EZNEC. Somewhat
more of a learning curve than MMANA but you can do just about anything you
can imagine with the pair. Small fees for both EZNEC and AutoEZ.
73/jeff/ac0c
www.ac0c.com
alpha-charlie-zero-charlie
-----Original Message-----
From: Ray Conrad NM2O
Sent: Monday, November 20, 2017 11:22 AM
To: towertalk@contesting.com
Subject: [TowerTalk] Yagi Optimizing Software
I have used YO in the past with good results.
It's still available on an old DOS computer.
What current software has optimizing routines?
I have older versions of YW and EZNEC.
I don't see optimizing routines in either.
73,
Ray
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|