Towertalk
[Top] [All Lists]

Re: [TowerTalk] Replacing Linear Loading on Force 12 40/20

To: Keith Dutson <kdutson@sbcglobal.net>
Subject: Re: [TowerTalk] Replacing Linear Loading on Force 12 40/20
From: Tom LeClerc W1TJL <w1tjl@arrl.net>
Date: Sun, 5 Nov 2017 16:08:48 -0500
List-post: <mailto:towertalk@contesting.com>
I also have a C4-XLD and have been having issues with the linear loading.
I did some searching on the net to see if these loading coil conversion
kits are still available and if so, from where.

Any ideas?

Thanks in advance and 73, Tom

On Nov 5, 2017 08:11, "Keith Dutson" <kdutson@sbcglobal.net> wrote:

> I have two F12 C-4XL antennas.  The linear loading design of the 40 meter
> elements proved efficient, but resulted in discovery of a major mechanical
> issue: it was easily damaged in high wind areas.  Although not observed, I
> believe the failure was caused by vibrations, which affected all mechanical
> joints.
>
> Tom N6BT recognized this problem and subsequently offered a conversion kit
> to replace this loading system with loading coils.  A relay at the feed
> point adds inductance to lower resonant frequency to the CW portion of the
> band.  Two of these kits were purchased.  One was installed and
> successfully
> tested at 20 feet.  It is currently on the ground, in pieces, awaiting
> cleanup, assembly and installation.  The other antenna is at the top of the
> tower, and will be taken down for conversion.  I am thinking about tuning
> one for CW and the other for SSB, thus eliminating the relays and control
> cables.  A WX0B Stack Match will connect the two antennas for operation.
>
> 73, Keith NM5G
>
> -----Original Message-----
> From: TowerTalk [mailto:towertalk-bounces@contesting.com] On Behalf Of Ray
> Conrad NM2O
> Sent: Saturday, November 4, 2017 9:56 PM
> To: towertalk@contesting.com
> Subject: [TowerTalk] Replacing Linear Loading on Force 12 40/20
>
> I have a Force 12 40/20. The 40 Meters is a two element beam, using linear
> loading. The loading is made from coperweld wire. I'm in NNY and subject to
> icing each winter.
>
>
> Has anyone converted to a loading coil to replace the linear loading?
>
>
> The result ould be similar to the Cushcraft 2 el 40 Meter that uses a
> loading coil.
>
>
> 73,
>
> Ray
>
> NM2O
>
> _______________________________________________
>
>
>
> _______________________________________________
> TowerTalk mailing list
> TowerTalk@contesting.com
> http://lists.contesting.com/mailman/listinfo/towertalk
>
> _______________________________________________
>
>
>
> _______________________________________________
> TowerTalk mailing list
> TowerTalk@contesting.com
> http://lists.contesting.com/mailman/listinfo/towertalk
>
_______________________________________________



_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk

<Prev in Thread] Current Thread [Next in Thread>