Dave,
I was begining to have issues with my Fulton winch but it didn't get to the
point where I couldn't move it at all, it was just very difficult to turn. I
just replaced my K1550 and I bought it off Amazon for roughly $99. Here is a
link to the winch. Good luck.
https://www.amazon.com/Fulton-K1550-0101-Brake-Winch/dp/B000KOROCI
73,ToddN4JRZ
On Sat, Oct 14, 2017 at 11:48 AM, DAVE WRIGHT via
TowerTalk<towertalk@contesting.com> wrote: Greetings,
I'm having a problem w/my winch on my Tri-Ex LM-354 tower. The stock hand-winch
is "stuck" & will not move "downward."
Apparently the friction clutch has stuck as it has not been moved much over the
last several years. It does move UP just fine. But when I try to go down, it
refuses to move; even when great strength is applied.
I've only managed to get it to move an inch or two after several tries. I fear
if I try too hard it may suddenly just come totally "free" & the tower will
"fall" all the way to the nested position, likey damaging the tower.
Should I continue to try to "force-it" down & take the chance of it falling? Or
should I try to "lever" or "jack" it past the "hard-spot?"
I likely will replace it after this problem is solved. No sense taking more
chances. I really appreciate any suggestions you may have. BTW, Tashijan Tower
has the part listed on their price/part listing as below:
| K1550 Fulton Winch | 041-0335 | 20 | $165.00 |
Thank you,
Dave K6JOX
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|