Towertalk
[Top] [All Lists]

Re: [TowerTalk] Tri-Ex winch problem

To: DAVE WRIGHT <kanives@yahoo.com>, "TowerTalk@contesting.com" <TowerTalk@contesting.com>
Subject: Re: [TowerTalk] Tri-Ex winch problem
From: Grant Saviers <grants2@pacbell.net>
Date: Sat, 14 Oct 2017 09:20:54 -0700
List-post: <mailto:towertalk@contesting.com>
The Fulton brakes eventually seize up or worse. If they can be covered from the WX all the better.

What you need is a "Klein Grip" to grab the cable and a come-along to take the tension off the winch. Then the winch can be replaced, the cable reattached, and then the tower lowered. It might be time to replace the cable, I did that on an LM-354. Measure the old cable and go to a wire rope shop and have them swage the end loop on an identical type replacement cable (don't use wire rope clips IMO).

https://www.zoro.com/klein-tools-haven-grip-frgd-06-25-cable-1604-10/i/G7452103/ is the cheapest but will likely damage a hoist cable

https://www.amazon.com/Klein-Tools-KT4500-Parallel-Jaw-Grip/dp/B00508HWLM has a longer grip length and cable diameter range. Very useful when working with guys.

A fellow ham might have one to borrow.

Grant KZ1W

On 10/14/2017 8:44 AM, DAVE WRIGHT via TowerTalk wrote:
Greetings,

I'm having a problem w/my winch on my Tri-Ex LM-354 tower. The stock hand-winch is "stuck" 
& will not move "downward."
Apparently the friction clutch has stuck as it has not been moved much over the 
last several years. It does move UP just fine. But when I try to go down, it 
refuses to move; even when great strength is applied.
I've only managed to get it to move an inch or two after several tries. I fear if I try too hard it may 
suddenly just come totally "free" & the tower will "fall" all the way to the 
nested position, likey damaging the tower.
Should I continue to try to "force-it" down & take the chance of it falling? Or should I try to 
"lever" or "jack"  it past the "hard-spot?"
I likely will replace it after this problem is solved. No sense taking more 
chances. I really appreciate any suggestions you may have. BTW, Tashijan Tower 
has the part listed on their price/part listing as below:

| K1550 Fulton Winch  | 041-0335  | 20 | $165.00 |



Thank you,
Dave K6JOX
_______________________________________________



_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk

_______________________________________________



_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk

<Prev in Thread] Current Thread [Next in Thread>