Many of us go bargain shopping and install marginal equipment. Those
choosing professionally re-purposed prop pitch motors such as those
provided by Kurt Andress complain less as they have little opportunity
to do so. Installations of equipment on your (below mentioned) list are
not the majority topics for a couple reasons: 1. They don't fail as
often and 2. They constitute a small minority of installations.
The above is my personal opinion. YMMV
Patrick NJ5G
On 9/21/2017 6:36 AM, Clay Autery wrote:
Curious why folks don't talk about the AlphaSpid RAK and BIG RAK
more.... These seem to be the answer to torque, braking, and mast
clamping...
______________________
Clay Autery, KY5G
(318) 518-1389
On 9/21/2017 12:25 AM, Jim Thomson wrote:
Date: Wed, 20 Sep 2017 17:52:20 -0700
From: David Needham <k8aja73@gmail.com>
To: K7LXC@aol.com
Cc: towertalk@contesting.com
Subject: Re: [TowerTalk] TowerTalk Digest, Vol 177, Issue 43
<Talking to the M2 Factory Tech Support today, apparently the DC motor,
<splined drive shaft and improved mast clamps came at the same time.
## I have both the DC version...and the AC version. They both have the
splined shaft,
and both have the same, lousy mast clamp.
## The original rotor was called an ORION OR-2300. It used a keyed shaft,
and an AC motor,
and a lousy mast clamp.
## When M2 bought out the rights to the OR-2300, they improved it with the
new splined shaft,
and higher torque, 2800 vs 2300 in lbs. M2s version of the mast clamp was an
improvement
over the original Orion OR-2300.
## M2 made ONE change later on, and switched from an AC motor to a DC motor.
The square
control boxes look identical, except one outputs dc instead of ac. No point
and shoot. Back then,
you could only buy both the rotor and box at the same time. Now you can buy
the rotor separate
from the box.
## The K7NV mast clamp for the OR-2800 rotor is a real treat, but it only
works for one diameter.
He can build them for any diameter you want. The K7LXC version is for 2 inch
OD only.
## The oem M2 mast clamp is less than desirable, even though it looks heavy
duty, and will work on
any mast from 1.9 inch OD up to 3.0 inch OD.
## The OR-2800, with DC motor, GH control box, and a real mast clamp is
serious $$$.
Jim VE7RF
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|