You can do that, but you will have to feed the tapered element dimensions
into a program to convert into the correct length for the non-tapered
element.
Chuck W5PR
On Sun, Sep 3, 2017 at 10:47 AM, Carol Richards <n2mm@comcast.net> wrote:
> Hello all,
>
>
> I am in the process of refurbishing a 5-element 6 meter beam. The first
> director uses a section of 3/4 inch tubing nested with a 5/8 inch piece of
> tubing. My aluminum supply is somewhat skimpy and I was wondering if I
> could replace the entire first director with a single piece of 1 inch
> tubing; no taper?
>
>
>
> Carol
>
> _______________________________________________
>
>
>
> _______________________________________________
> TowerTalk mailing list
> TowerTalk@contesting.com
> http://lists.contesting.com/mailman/listinfo/towertalk
>
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|