Roger,
That is weird. Checked a can of old Nyloks that had been outside for years.
The nylon insert looked fine. Been using Nyloks for years without that issue
up to 5/8". Except for the tower (Rohn galvanized) itself and the rotator to
mast clamps (plated #8 hardened bolts so I can really crank down on them),
all hardware including u-bolts are SS using Nyloks with anti-seize. No lock
washers. I just use flat washers. Never had a nut loosen after 24 years. I
do not reuse Nyloks, just in case.
73,
N2TK, Tony
-----Original Message-----
From: TowerTalk [mailto:towertalk-bounces@contesting.com] On Behalf Of Roger
(K8RI) on TT
Sent: Thursday, July 06, 2017 3:58 AM
To: towertalk@contesting.com
Subject: [TowerTalk] Nylok nuts
Nylok nuts do not last around here. I thought it was UV, but many have told
me that Nylon is impervious, or resistant to UV. I had based my thoughts
that the nuts oriented so the nylon was up were the first to go. The nylon
virtually disappeared out of them, so I finally gave up on them.
73
Roger (K8RI)
---
This email has been checked for viruses by Avast antivirus software.
https://www.avast.com/antivirus
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|