It could be the tower was deemed unsafe for future use and by cutting it,
forces the issue.
(Just speculation on my part)
Too bad if the tower was in good shape, I refer to your comment "idiot ".
Regards,
Mark, K1RX
> On Jun 16, 2017, at 2:59 PM, <w5prchuck@gmail.com> <w5prchuck@gmail.com>
> wrote:
>
> Anything is possible, however, you will likely never be able to get the tower
> straight because the “idiot” surely didn’t make each cut in exactly the same
> place on the tower. By the way, it would have been faster and safer to
> remove the bolts IMHO.
>
> Chuck W5PR
>
> Sent from Mail for Windows 10
>
> From: Gary Johnson
> Sent: Friday, June 16, 2017 1:38 PM
> To: towertalk@contesting.com
> Subject: [TowerTalk] Rohn 25 question
>
> I was given 6 sections of Rohn 25 that some idiot with a sawzall disassembled
> by cutting off the ears that fit into the next section vs unbolting. Is it
> possible to remove the bolted in ears and reassemble using a section of pipe
> the correct diameter bolting it both above and below??
>
> 73
>
> Gary J
> N5BAA
> _______________________________________________
>
>
>
> _______________________________________________
> TowerTalk mailing list
> TowerTalk@contesting.com
> http://lists.contesting.com/mailman/listinfo/towertalk
>
> _______________________________________________
>
>
>
> _______________________________________________
> TowerTalk mailing list
> TowerTalk@contesting.com
> http://lists.contesting.com/mailman/listinfo/towertalk
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|