Thanks Jim
wiring is with multi cables from Bandmaster to Sixpack control unit screws
I know is better to have all from same manufacturer, if something fail,
thet will say the fail is in the other products, hi hi
73,
Jorge
2016-12-07 15:14 GMT-03:00 Jim Brown <jim@audiosystemsgroup.com>:
> On Wed,12/7/2016 9:56 AM, Jorge Diez - CX6VM wrote:
>
>> My idea is to replace just SixPack and keep my two Bandmasters III as
>> bandecoders
>>
>> May I use the 4O3A Antenna Genius 8 x 2 Plus? Or I will need to change my
>> band decoders also?
>>
>
> Jorge,
>
> I don't know the Bandmaster decoders, but all I had to do was rewire
> between the band decoder and the 4O3A unit. It can be set for one relay
> line per antenna, positive or ground switched, or for BCD, or for control
> via the Ethernet port.
>
> Relay and BCD lines go to a DB15 connector, there are DIP switches to
> choose the relay logic.
>
>
> 73, Jim K9YC
>
> _______________________________________________
>
>
>
> _______________________________________________
> TowerTalk mailing list
> TowerTalk@contesting.com
> http://lists.contesting.com/mailman/listinfo/towertalk
>
--
73,
Jorge
CX6VM/CW5W
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|