Rudy,
I've been running the 8x2 switch for the last several months. It works
awesome with my FLex 6700 as the control signals are all handled over
the network.
I believe the dip switches can be setup for BCD signals or an external
selection type switch if a rig other than a Flex is used.
I did have one problem with a control card inside the switch.
Support/warranty was excellent and very timely. They ended up sending
me a new card that I was easily able to swap out on my bench. The bad
card only affected one side of the switch so I was still up and running
so I could work dx between contests.
I'm looking forward to the 403A Power Genius amp. It's going to be an
SO2R amp to go along with the 6700. All band and ptt signals will be
handled over the network. Going with the Flex solution has reduced the
number of black boxes and cabling, significantly.
Rich - N5ZC
On 12/7/2016 10:47 AM, Rudy Bakalov via TowerTalk wrote:
I am thinking of replacing my existing switches with Ranko's Genius product
line. The main driver is its infinite expandability and ability to control
remotely over the Internet.
Would greatly appreciate the opportunity to compare notes with anyone who has
installed the Genius switching gear.
73, Rudy N2WQ
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|