I have the schematic for the 450A which is an AC rotor. If you want a copy I
can send the PDF.
73 Joe K2UF
-----Original Message-----
From: TowerTalk [mailto:towertalk-bounces@contesting.com] On Behalf Of Henk
PA5KT
Sent: Monday, November 21, 2016 3:39 AM
To: towertalk@contesting.com
Subject: Re: [TowerTalk] Yaesu G-8000 DXA controller with G-450 rotor
The G450XL uses an AC24V motor.
G800/1000 models are DC 24 V.
Not interchangeble.
Dont know if the G450A is the same as G450XL. I cannot find a schematic of
the G450A.
If it uses 3 wires to control your motor it is AC.
2 wires it is DC.
73 Henk PA5KT
Op 11/17/2016 om 14:36 schreef Herbert Schoenbohm:
> I have an orphan Yaesu G-8000DXA controller and would like to know if
> I can replace by G-450A control box with it without any
> modification? The plugs are the same and from the schematic the
> control circuit is similar. But I would like to know first before I
> brick the rotor on the tower. Please help.
>
>
>
> Herb Schoenbohm, KV4FZ
>
> _______________________________________________
>
>
>
> _______________________________________________
> TowerTalk mailing list
> TowerTalk@contesting.com
> http://lists.contesting.com/mailman/listinfo/towertalk
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
-----
No virus found in this message.
Checked by AVG - www.avg.com
Version: 2016.0.7924 / Virus Database: 4664/13447 - Release Date: 11/21/16
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|