First off, I think you mean G-800DXA, not G-8000DXA.
The connectors are indeed identical on both units and the interconnect
cable between rotor and controller is also identical, but...
The G-800DXA uses only pins 4 & 5 for the limits and motor, where the
G-450DXA uses pins 4, 5 & 6. Pin 7 is never used on these rotors.
The potentiometer wiring is identical, uses pins 1, 2 & 3.
Unless you can ID the motor differences, if any, I would hesitate to
substitute and create a brick.
As per the previous suggestion, check with Yaesu Tech first.
Tom W3FRG
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|