Re: [TowerTalk] C19XR Feed Point Parallel Wire Connection.

["Roger (K8RI) on TT" <K8RI-on-TowerTalk@tm.net>]

On the C19XR it's closer too 20-21 inches

Thanks to all who answered

73

Roger (K8RI)

On 11/11/2016 Friday 6:18 AM, AE1P wrote:
> Roger,
>
>
> A piece of #14 romex with the ground pulled out would be better, I 
> can't remember exact length,
> but I believe it was around 12-14"... I have a pic on Photobucket 
> somewhere ,just type in AE1P...
> Hope this helps...
>
> 73,
>
> Neil
>
> AE1P
>
>
> On 11/11/2016 6:13 AM, Roger (K8RI) on TT wrote:
> > The driver assembly instructions for the C19XR say:  " The next part 
> > installs the parallel driver wires between the 10 mtr driver feed 
> > points and the 20 mtr feed points"  I do not have this part, or even 
> > a photo.
> > Outside of ordering this part and waiting-- Would a piece of 450 ohm 
> > ladder line work for this?  Otherwise, what would be better?
> > 73
> >
> > Roger (K8RI)
> >
> >
> > ---
> > This email has been checked for viruses by Avast antivirus software.
> > https://www.avast.com/antivirus
> >
> >
> > _______________________________________________
> >
> >
> >
> > _______________________________________________
> > TowerTalk mailing list
> > TowerTalk@contesting.com
> > http://lists.contesting.com/mailman/listinfo/towertalk

--

73

Roger (K8RI)


---
This email has been checked for viruses by Avast antivirus software.
https://www.avast.com/antivirus


_______________________________________________



_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk