Re: [TowerTalk] C19XR Feed Point Parallel Wire Connection.

[AE1P <ae1p@arrl.net>]

Roger,


A piece of #14 romex with the ground pulled out would be better, I can't 
remember exact length,
but I believe it was around 12-14"... I have a pic on Photobucket 
somewhere ,just type in AE1P...
Hope this helps...

73,

Neil

AE1P


On 11/11/2016 6:13 AM, Roger (K8RI) on TT wrote:
> The driver assembly instructions for the C19XR say:  " The next part 
> installs the parallel driver wires between the 10 mtr driver feed 
> points and the 20 mtr feed points"  I do not have this part, or even a 
> photo.
> Outside of ordering this part and waiting-- Would a piece of 450 ohm 
> ladder line work for this?  Otherwise, what would be better?
> 73
>
> Roger (K8RI)
>
>
> ---
> This email has been checked for viruses by Avast antivirus software.
> https://www.avast.com/antivirus
>
>
> _______________________________________________
>
>
>
> _______________________________________________
> TowerTalk mailing list
> TowerTalk@contesting.com
> http://lists.contesting.com/mailman/listinfo/towertalk
--
73,
Neil,
AE1P

_______________________________________________



_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk