Hi John.
That was my idea as well. I have a friend with a machine shop.
I looked at the Mc master website and almost found it... Unfortunately they
don't have the 24 pitch 18 tooth steel rod gear.
Regards Jan.
Verzonden door BlueMail
Op 21 okt. 2016 19:08, bij 19:08, "john@kk9a.com" <john@kk9a.com> schreef:
>A few years ago I need a spur gear for a TIC Ring Rotator that was
>unobtainable from the manufacture. I could not find a matching one at
>any
>gear supplier either so I purchased gear stock at McMaster-Carr. I have
>access to a machine shop and I was able to cut it to length, bore the
>hole, etc. In another instance when I needed a gear I found a very
>similar
>one and just had to bore and broach the hole to fit the shaft. So look
>for something close and then bring it to a machine shop.
>
>GL,
>John KK9A
>
>To: Towertalk@contesting.com
>Subject: [TowerTalk] Looking for gear.
>From: Nieuws <nieuws@on6zg.be>
>Date: Fri, 21 Oct 2016 17:06:13 +0200
>
>Hi.
>
>I am looking for a spur gear / pinion to fix an or2300 rotator.
>It's a 18 tooth 24 DP Gear 1.5 inches in length.
>I can't seem to find a European source for a gear like this. Does
>anyone
>have a
>supplier or know where to get it?
>
>Best regards
>Jan Engelen ON6ZG
>
>_______________________________________________
>
>
>
>_______________________________________________
>TowerTalk mailing list
>TowerTalk@contesting.com
>http://lists.contesting.com/mailman/listinfo/towertalk
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|