A few years ago I need a spur gear for a TIC Ring Rotator that was
unobtainable from the manufacture. I could not find a matching one at any
gear supplier either so I purchased gear stock at McMaster-Carr. I have
access to a machine shop and I was able to cut it to length, bore the
hole, etc. In another instance when I needed a gear I found a very similar
one and just had to bore and broach the hole to fit the shaft. So look
for something close and then bring it to a machine shop.
GL,
John KK9A
To: Towertalk@contesting.com
Subject: [TowerTalk] Looking for gear.
From: Nieuws <nieuws@on6zg.be>
Date: Fri, 21 Oct 2016 17:06:13 +0200
Hi.
I am looking for a spur gear / pinion to fix an or2300 rotator.
It's a 18 tooth 24 DP Gear 1.5 inches in length.
I can't seem to find a European source for a gear like this. Does anyone
have a
supplier or know where to get it?
Best regards
Jan Engelen ON6ZG
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|