| To: | "towertalk" <towertalk@contesting.com> |
|---|---|
| Subject: | [TowerTalk] Rotor Control Cable |
| From: | "Wilson" <infomet@embarqmail.com> |
| Reply-to: | Wilson <infomet@embarqmail.com> |
| Date: | Tue, 10 May 2016 12:23:42 -0400 |
| List-post: | <towertalk@contesting.com">mailto:towertalk@contesting.com> |
Did u check the wire gauges? If your run is “long”, you need two motor power wires of larger gauge. I don’t know what “long” is. WL _______________________________________________ _______________________________________________ TowerTalk mailing list TowerTalk@contesting.com http://lists.contesting.com/mailman/listinfo/towertalk |
| <Prev in Thread] | Current Thread | [Next in Thread> |
|---|---|---|
| ||
| Previous by Date: | Re: [TowerTalk] Rotor Control Cable, john@kk9a.com |
|---|---|
| Next by Date: | Re: [TowerTalk] Rotor Control Cable, W5GN |
| Previous by Thread: | Re: [TowerTalk] Rotator Control Cable, Roger (K8RI) on TT |
| Next by Thread: | Re: [TowerTalk] Rotor Control Cable, W5GN |
| Indexes: | [Date] [Thread] [Top] [All Lists] |