Towertalk
[Top] [All Lists]

Re: [TowerTalk] Rotor Control Cable

To: towertalk@contesting.com
Subject: Re: [TowerTalk] Rotor Control Cable
From: "john@kk9a.com" <john@kk9a.com>
Date: Tue, 10 May 2016 12:15:59 -0400
List-post: <towertalk@contesting.com">mailto:towertalk@contesting.com>
It has been decades since I bought actual rotator cable. Typically the
motor requires a larger conductor than the sensing wires so I would
imagine that actual eight wire rotator cable would have two larger gauge
wires and six smaller ones.

John KK9A


To:     Tower Talk <towertalk@contesting.com>
Subject:        [TowerTalk] Rotor Control Cable
From:   "Timothy A. Holmes" <taholmes160@gmail.com>
Reply-to:       taholmes160@gmail.com
Date:   Mon, 9 May 2016 17:25:32 -0400

Hi Guys - another one for the pile of questions

I was looking through the DXE catalog the other night and noticed that 8
conductor rotor cable is .89 cents a foot, and 4 conductor is .29 cents a
foot. ASSUMING (and yes, I know the rules about assuming) Since I haven't
looked it up online YET, that the wire gauge is the same in both types of
cable, is there any hurt, harm or danger in using 2 runs of the 4
conductor (total of about 60 dollars) vs 1 run of the 8 conductor (about
90 dollars)?

I should note that I am currently using 2 runs of cable for the rotor and
it works great -- I want to do this "right" but I also want to be sensible
with my budget

Thanks
TIM
W8TAH

_______________________________________________



_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk

<Prev in Thread] Current Thread [Next in Thread>