If you have LEDs on the front panel of the controller for CW, CCW and
brake the controller is actually from the Tailtwister - check that
schematic.
Those diodes (CR3, CR4, and CR5) would be the same "rectifier" type as
CR1. 1N4008 should work just fine although I doubt a fuse will help
much ... you would need something like 1/16 A (0.06 mA) in series with
terminal 9.
73,
... Joe, W4TV
On 3/3/2016 7:00 PM, Bill Feissner wrote:
Hey Joe,
No, not the terminal connections. I am looking right at the meter pc
board. On the top of the board on the left side of it are one diode and
a resistor under it and another diode with a resistor under it. On the
right side of the top of the board is a diode with a resistor under it.
CR1 and VR1 and 2 other resistors are towards the bottom half of the
board. I may just change the diodes that check bad with IN4008's and put
a fuse in and see what happens. Thanks for the help and interest. If
interested I can take a pic of it for those that would like to see it.
Bill AI3Q
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|