I think Stan has a good suggestion. I think that the best you'll get out
of Rohn would be replacement bolts with the same tight fit. You can
purchased galvanized nuts at McMaster-Carr, Fastenal, etc.
John KK9A
To: "tower" <towertalk@contesting.com>
Subject: Re: [TowerTalk] Rohn Bolts AND nuts - won't mate
From: "StellarCAT" <rxdesign@ssvecnet.com>
Date: Tue, 26 Jan 2016 09:06:21 -0500
Thanks for the replies guys... so this is indeed somewhat new. My last tower,
bought new in 2005, did not have these nuts. So its been since then. And I?m
sure others would have chimed in if it were anything older than say the last
few years so it must be quite a bit new.
As for buying other things ? like replacement nuts or spray galvanizing ? I
paid for proper bolt kits and that is what I expect to have. These as far
as I
can tell with only the one ?set? opened are not useable.
I?ll see if Rohn can replace the nuts with their standard nuts from the
past. I
never had a problem with them nor have I ever heard of them loosening. The
?over-dipped? galvanizing on the old ones, bolts and nuts, already made them
stay put when tightened. This is far too much of an overkill.
Gary
K9RX
Gary,If I were you, instead of fighting it, I would buy galvanized (tapped
oversize) hex nuts and use them instead of the locknuts. I don't know when
they
started using locknuts, but for decades they did not use them. There are
thousands of towers installed without locknuts and without problems as a
result.73... Stan, K5GO> On Jan 25, 2016, at 8:03 PM, StellarCAT
rxdesign@ssvecnet.com> wrote:
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|