It may take me a few days to check, but a local ham (now a SK) had, I
believe 4 stock sections. He planned on mounting the rotator at the
bottom of a 25G (IO believe stock is 24')b ut they were so heavy that I
convinced him to install a separate mount for the rotator on its own
foundation. Unfortunately, IIRC they exceeded the load limit for the
rotator. 2" with 0.5" wall was so heavy, it seems IIRC I could not lit
one end of a section. At that time I could press 150#, military, or bench.
At-any-rate, if it wasn't sold as part of the estate. His wife is a ham
and may still have them. I'll check if you are interested. Shipping
from MI would probably be as much as a whole tower, as I say, they are
heavy! If they are still around, I'm sure the price would be right.
Bill had one whale of a station. I spent 8 hours on his tower working on
that monster ant. I's sure it was sold.
73
Roger (K8RI)
.
On 9/14/2015 1:33 PM, Stephen Davis wrote:
Hello all
Specs : 20 ft. 2" O.D. .50" wall chrome moly
Yep, .5 " !
Tnx a lot. 73. Steve. K1PEK
Steve Davis
Senior RF Cable Design Engr.
& Founder
DAVIS RF Co. a division of
Orion Wire Co., Inc.
Tel: 978-369-1738
ALSO: Davis Rope & Cable Assembly Co., LLC:
Design Engrs, Distribution
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
--
73
Roger (K8RI)
---
This email has been checked for viruses by Avast antivirus software.
https://www.avast.com/antivirus
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|