Towertalk
[Top] [All Lists]

Re: [TowerTalk] Shorty Forty Hose Clamp thread

To: "'Jim Thomson'" <jim.thom@telus.net>
Subject: Re: [TowerTalk] Shorty Forty Hose Clamp thread
From: "Doug Renwick" <ve5ra@sasktel.net>
Date: Thu, 13 Aug 2015 07:40:26 -0600
List-post: <towertalk@contesting.com">mailto:towertalk@contesting.com>
Jim,
How many SS hose clamps have you stripped?  I stripped too many because I
could not get the clamp tight enough to prevent the smaller element from
turning inside the larger.  I also found that with more penetrox applied, a
tighter hose clamp is required.  So my experience differs from yours.

So torque your gear clamp to the max spec and the smaller element still
turns inside the larger.  Common sense would tell you to tighten that clamp
further, possibly stripping it, unless you lubricate it.

You have seen my antennas; are there antenna elements falling off
everywhere?

Doug

I wasn't born in Saskatchewan, but I got here as soon as I could.

-----Original Message-----

##  If you tq to their MAX  tq figures, the smaller tubing inside will not
spin, even if
you slop penetrox on it.   Unless the yagi tips have to be adjustable, then
maybe use 
SS hose clamps for the tips only.   The rest of the yagi should be using  3
x rivets
at each joint. 

Jim  VE7RF


---
This email has been checked for viruses by Avast antivirus software.
https://www.avast.com/antivirus

_______________________________________________



_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk

<Prev in Thread] Current Thread [Next in Thread>