Towertalk
[Top] [All Lists]

Re: [TowerTalk] Rohn towers

To: Jon Pearl - W4ABC <jonpearl@tampabay.rr.com>
Subject: Re: [TowerTalk] Rohn towers
From: Bry Carling <bcarling@cfl.rr.com>
Date: Sun, 10 May 2015 15:00:55 -0400
List-post: <towertalk@contesting.com">mailto:towertalk@contesting.com>
This looks like good advice. Thank you. There alloy tubing starts at 3 inches 
in diameter and up but I expect they have something else I can use.

Best regards - Brian Carling
AF4K Crystals Co.
117 Sterling Pine St.
Sanford, FL 32773

Tel: +USA 321-262-5471




> On May 10, 2015, at 2:54 PM, Jon Pearl - W4ABC <jonpearl@tampabay.rr.com> 
> wrote:
> 
> Orlando is right around the corner from you...
> 
> http://www.alro.com/locations/locationsmain.aspx?Loc=FL
> 
> 
> 
> 
> 
> 73,
> 
> 
> Jon Pearl - W4ABC
> www.w4abc.com
> 
> 
> 
>> On 5/10/2015 1:30 PM, Bry Carling wrote:
>> Thank you everyone. It sounds like I will just need to go with a much longer 
>> mast.
>> 
>> Best regards - Brian Carling
>> AF4K Crystals Co.
>> 117 Sterling Pine St.
>> Sanford, FL 32773
>> 
>> Tel: +USA 321-262-5471
>> 
>> 
>> 
>> 
>>> On May 10, 2015, at 11:29 AM, greenacres113@charter.net wrote:
>>> 
>>> 
>>> 
>>>    The 4 Rohn 25 towers I have up I mounted the rotor plale in the area
>>> between sections. Between the top section & the next one from the top.
>>> A lot depends on the rotor plate. Some generic plates have the U bolts
>>> welded on & that's the only way to mount them. It's easier if you can
>>> to mount the rotor plate in that joint area & put a Ham series on the
>>> plate before putting the top section on. It turns freely in that area.
>>> On my R45 the Tailtwister has lots of turning room. My R45 has a
>>> thrust bearing on top. It was easier to mount the rotor mid top
>>> section then lower the mast thru the thrust bearing into the rotor. We
>>> used a manlift which made it simple.
>>> 
>>>    K9IL
>>> _______________________________________________
>>> 
>>> 
>>> 
>>> _______________________________________________
>>> TowerTalk mailing list
>>> TowerTalk@contesting.com
>>> http://lists.contesting.com/mailman/listinfo/towertalk
>> _______________________________________________
>> 
>> 
>> 
>> _______________________________________________
>> TowerTalk mailing list
>> TowerTalk@contesting.com
>> http://lists.contesting.com/mailman/listinfo/towertalk
>> 
> 
> 
> ---
> This email has been checked for viruses by Avast antivirus software.
> http://www.avast.com
> 
> _______________________________________________
> 
> 
> 
> _______________________________________________
> TowerTalk mailing list
> TowerTalk@contesting.com
> http://lists.contesting.com/mailman/listinfo/towertalk
_______________________________________________



_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk

<Prev in Thread] Current Thread [Next in Thread>