Thank you everyone. It sounds like I will just need to go with a much longer
mast.
Best regards - Brian Carling
AF4K Crystals Co.
117 Sterling Pine St.
Sanford, FL 32773
Tel: +USA 321-262-5471
> On May 10, 2015, at 11:29 AM, greenacres113@charter.net wrote:
>
>
>
> The 4 Rohn 25 towers I have up I mounted the rotor plale in the area
> between sections. Between the top section & the next one from the top.
> A lot depends on the rotor plate. Some generic plates have the U bolts
> welded on & that's the only way to mount them. It's easier if you can
> to mount the rotor plate in that joint area & put a Ham series on the
> plate before putting the top section on. It turns freely in that area.
> On my R45 the Tailtwister has lots of turning room. My R45 has a
> thrust bearing on top. It was easier to mount the rotor mid top
> section then lower the mast thru the thrust bearing into the rotor. We
> used a manlift which made it simple.
>
> K9IL
> _______________________________________________
>
>
>
> _______________________________________________
> TowerTalk mailing list
> TowerTalk@contesting.com
> http://lists.contesting.com/mailman/listinfo/towertalk
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|